When No Routing Job Is Over Completion to 2 Subinventories at Same Time, WIPTXCMP Form Fails With WIP_LESS_QTY Error (Doc ID 2182980.1)

Last updated on SEPTEMBER 15, 2016

Applies to:

Oracle Work in Process - Version 12.1.3 and later
Information in this document applies to any platform.

Symptoms

Actual Behavior
When creating the over completion transaction for subassembly item's job to 2 subinventories,
on completion transactions FORM(WIPTXCMP), "WIP_LESS_QTY" error occurs.


ERROR
This errors message is as follows:
 "Quantity required to complete this transaction no longer available"


STEPS
The issue can be reproduced at will with the following steps:

  1. Create a new assembly item with one component with supply type to be assembly pull and Subinventory to be XXX and without routing.
    Bills Of Materials(N) > Bills > Bills
  2. Set the over completion to be 100% in WIP parameter.
    WIP(N) > Setup > Parameters
  3. Create and release a new job with start quantity to be 100.
    WIP(N) > Discrete > Discrete Jobs
  4. Move the component to the last operation's to Move step.
    WIP(N) > Move Transactions > Move Transactions
  5. Open the completion Transaction forms,
    WIP(N) > Material Transactions > Completion Transactions
     Type:WIP Completion.
     Over completion checked.
     Click the "Continue" button.
  6. Set two line to complete,
    one is "XXX" with Transaction quantity to be 110,
    and the other "YYY" with Transaction quantity to be 1.
  7. Click "done" button
  8. Pop up the following error message
    "Quantity required to complete this transaction no longer available"

Cause

Sign In with your My Oracle Support account

Don't have a My Oracle Support account? Click to get started

My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms