MSCA Physical Counting Updates Lot Attributes

(Doc ID 2305162.1)

Last updated on APRIL 27, 2018

Applies to:

Oracle Inventory Management - Version 12.1.3 and later
Information in this document applies to any platform.

Symptoms

ACTUAL BEHAVIOR
---------------
Physical Counted Lot Attributes change when users perform Physical Counting for an Item from Mobile GUI .
User enters an incorrect Lot number and does not complete this transaction ,instead uses the navigation to return to previous menu,

Users now enters the correct Lot number and completes the count.
After this step is performed, users can observe that below information was changed for the Counted Lot number:

Origination date was changed
Hold date was populated
Retest date was populated

EXPECTED BEHAVIOR
-----------------------
Users expect that after Physical Counting,the values for Origination date ,Hold date and Retest date would be unchanged, if the seeded navigation is used to cancel current transaction and return to previous page/menu.

STEPS
-----------------------
The issue can be reproduced at will with the following steps:

1 From MSCA GUI ->Inventory --> Counting --> Physical count--> Count using LPN -select Detail.

Perform Physical Counting for an Item which is lot controlled.

2 Enter an incorrect Lot number during counting and do not complete this transaction ,instead uses the navigation to return to previous menu.

3 Observe the above mentioned behavior,with seeded columns being updated.



Changes

 

Cause

Sign In with your My Oracle Support account

Don't have a My Oracle Support account? Click to get started

My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms