Reassigning Contractor Requisition To Another Buyer From Unassigned Queue Removes The Assignment Start And End Date

(Doc ID 2323733.1)

Last updated on NOVEMBER 01, 2017

Applies to:

Oracle iProcurement - Version 12.2.5 and later
Information in this document applies to any platform.

Symptoms

On : 12.2.5 version, Services Procurement

ACTUAL BEHAVIOR
---------------
After creating a contractor requisition with start and end dates, when the requisition is reassigned from the unassigned queue to a buyer queue it removes the assignment start and end date of the contractor.

EXPECTED BEHAVIOR
-----------------------
Expect the start date and end date should not get removed.

STEPS TO REPRODUCE
-----------------------------------
The issue can be reproduced at will with the following steps:

1.Navigate to iProcurement > Contractor Request and create a requisition 14622 with contractor.
2. Approve the requisition and assign contractor.
3. Approve again.
4. set profile CLM Installed to Y at site level,set profile CLM Enabled to N at responsibility level(if can't query out,then don't need to set)
5. Navigate to Purchasing Buyer Work Center > Requisitions > Demand Work Bench. Query the requisition and click "Reassign".
6. Choose another Buyer, click "Apply".
7. Verify data in db and found that the requisition's assignment start/end date in po_requisition_lines_all were clear.



Cause

Sign In with your My Oracle Support account

Don't have a My Oracle Support account? Click to get started

My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms