My Oracle Support Banner

Running Endeca Graph after Cloning Endeca Instance Fails with Error Cannot Allocate Bulk Load Port On Disabled Data Domain: Eam (Doc ID 2361138.1)

Last updated on MARCH 25, 2019

Applies to:

Oracle Enterprise Asset Management - Version 12.2.6 and later
Information in this document applies to any platform.


On : 12.2.6 version, Information Discovery (v6 and higher)

When attempting to run reset data store or full load graph, for a newly cloned Endeca artifacts based on note 2097196.1, the following error occurs.

Caused by: org.jetel.exception.JetelRuntimeException: Failed with the following ManageFault:
OES-000178: Cannot allocate bulk load port on disabled data domain: eam

The issue can be reproduced at will with the following steps:
1. Clone Endeca artifacts as per note Doc ID 2097196.1
2. Perform reset data store and observe error
3. Perform full load and observe error


To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!

In this Document

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.