For Quality Samples, on the Quality Change Disposition Form, Default "Lot Status To" Field Does Not Default Correctly Based on Specification Validity Rule Setup (Doc ID 2409158.1)

Last updated on DECEMBER 13, 2021

Applies to:

Symptoms

ACTUAL BEHAVIOR 

---------------

Sample Disposition Change does not  default Lot Status To based on Validity Rule 

After entering the Results for the Sample, in case when it is an out of Spec Result; the disposition of sample is set to In progress as expected.

When finally trying to change the disposition of the sample, the change disposition To field defaults to "Accept with Variance" and the Change Lot status is Defaulted to the In-Spec Status set in the Validity rule e.g  "Released"

When change the disposition to Reject the Change Lot status TO is still says "Released", but it should be changed to the Out-Spec Status set in the Validity rule e.g "Quality-Hold"

EXPECTED BEHAVIOR

-----------------------

On Change Disposition, expect Lot Status To field to default correctly based on validity rule setup and sample disposition.

STEPS

-----------------------

The issue can be reproduced at will with the following steps:

1. Responsibility: Quality Manager

2. Navigation: Samples > Item Samples

3. Query Sample

4. Actions > Change Disposition

Cause

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.