Locator Confirmation Is Not Working In Pick Load Page When Serials Are Allocated (Doc ID 2424384.1)

Last updated on SEPTEMBER 16, 2019

Applies to:

Symptoms

In the Pick Load page , performing a Pick task for a Discrete Job, When users are trying to confirm the suggested locator, the system shows message "Invalid Value" even though the exact same value is confirmed.

Users have Locator alias enabled for this Subinventory and when they enter the Locator Alias name , then the following message is shown

ERROR
-----------------------
Serials allocated. You can pick only those serials allocated for this task

STEPS
-----------------------
The issue can be reproduced at will with the following steps:
1. Accept the WIP Pick Task using the Mobile GUI Application
2. Confirm the Subinventory
3. Confirm the locator value exactly same as suggested. Receive Invalid Value error
4. Enter the Locator Alias and receive the Message
       "Serials allocated. You can pick only those serials allocated for this task"

Changes

Cause

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.