Process Manufacturing Financial Inventory Valuation Report (XML) Fails With Errors APP-FND-00762 and APP-FND-00730 (Doc ID 2669035.1)

Last updated on APRIL 04, 2025

Applies to:

Symptoms

On : 12.1.3 version, Reports

When attempting to run the Inventory Valuation Report (XML)
the following error occurs.

ERROR
-----------------------
APP-FND-00762: Routine FDFSSR found segment To Item has invalid range validation data. The flexfield segment To Item is defined as either a Low or a High segment and there is no corresponding High or Low segment in this flexfield structure. Range segments that use Low or High designations must occur in matched pairs within a flexfield structure.

Redefine your flexfield segments so that you define matched pairs of Low and High segments, preferably as consecutive segments. Your segments do not
necessarily need to use the same value set.

APP-FND-00730: This flexfield has an invalid value set. It may use a special value set that uses an Edit event user exit, and the user exit has failed. If you are using a form on a graphical user interface (GUI) you may have an invalid value set of a different type, possibly a table-validated value set where the table or view does not exist or where there is an invalid WHERE clause.

Contact your system administrator or support representative to check and correct the value sets this flexfield uses.


STEPS
-----------------------
The issue can be reproduced at will with the following steps:
1. Responsibility: OPM Financials
2. Navigation: Submit > Run > Inventory Valuation Report (XML)

Cause

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.