My Oracle Support Banner

Mass Search And Replace Does Not Update Unit of Measure When Replacing Ingredient with New Ingredient with Different Primary UOM (Doc ID 2767145.1)

Last updated on APRIL 08, 2022

Applies to:

Oracle Process Manufacturing Product Development - Version 12.1.3 and later
Information in this document applies to any platform.

Symptoms

On : 12.1.3 version, Product Development Mass Search And Replace

ACTUAL BEHAVIOR
---------------
When using Mass Search and Replace to replace one ingredient with another in a formula, and the new ingredient has a different primary UOM than the original ingredient, when the replacement is done the formula retains the UOM that was on the ingredient line, instead of replacing it with the new ingredient's primary UOM. This occurs even if there is no UOM conversion from the new ingredient's primary UOM to the UOM on the ingredient line.

EXPECTED BEHAVIOR
-----------------------
Expect the ingredient line to be updated with the primary UOM of the new ingredient. If you update the formula manually, the new ingredient's primary UOM is pulled in to the form.

STEPS
-----------------------
The issue can be reproduced at will with the following steps:
1. Formulator > Mass Search and Replace
2. Find Formulas. Replace Ingredient.



Changes

 

Cause

To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!


In this Document
Symptoms
Changes
Cause
Solution
References


My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.