DFF LOV Button Is Missing In Pull Sequence Setup For eKanban
(Doc ID 2849786.1)
Last updated on FEBRUARY 23, 2022
Applies to:
Oracle Flow Manufacturing - Version 12.2.9 and laterInformation in this document applies to any platform.
Symptoms
On FLM - Oracle Flow Manufacturing, 12.2.9 version, eKaban
ACTUAL BEHAVIOR
-----------------------
Table validated value set is not generating the LOV in the eKanban Planning Workbench for Pull Sequences DFF.
EXPECTED BEHAVIOR
-----------------------
Pull Sequences DFF works fine in the Pull Sequences form but in eKanban Planning Dashboard, is not opening the LOV.
STEPS
-----------------------
The issue can be reproduced at will with the following steps:
1. Add simple table validation value set in order to assign LOV for the Pull Sequences single-segment DFF
2. Check the LOV in Pull Sequences form > works fine.
3. Go to eKanban Super User responsibility
4. Open Setup tab
5. Pull Sequence Details > Planning tab
Changes
Cause
To view full details, sign in with your My Oracle Support account. |
|
Don't have a My Oracle Support account? Click to get started! |
In this Document
| Symptoms |
| Changes |
| Cause |
| Solution |
| References |