General Ledger Enterprise Command Center (GL ECC) Data Load Program Error: job failed with error code:Invalid state and after this, data load for a dataset is empty. (Doc ID 2959164.1)

Last updated on DECEMBER 10, 2024

Applies to:

Symptoms

When attempting to run GLECCDLCP: General Ledger Command Center Data Load, the following error occurs:

ERROR:
ERROR job failed with error code:Invalid state and after this, data load for a dataset is empty. Full load (with reset) must run before running any incremental load flow. Invalid state: Trying to run data load for a dataset that seems to be empty. Full load (with reset) must run before running any incremental load flow.

The issue can be reproduced at will with the following steps:

1. Use General Ledger Super User Responsibility.

2. Navigate to Submit Requests and launch General Ledger Command Center Data Load concurrent.

3. The above concurrent will trigger the Enterprise Command Center Run Data Load.

4. Check and see errors mentioned above.

Changes

Install of the new Enterprise Command Center General Ledger

Cause

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.