Cannot Resequence Stops For a Fleet Depot Shipment (Doc ID 457770.1)

Last updated on SEPTEMBER 08, 2016

Applies to:

Oracle Transportation Management - Version: 5.5.2
This problem can occur on any platform.

Symptoms

-- Problem Statement:
Unable to re-sequence stops on a multistop shipment when the shipment is associated to a depot.

Steps to Reproduce: 

1 - Create a Depot Profile to start at A and end at A.
(Use help for instruction on how to configure and use a Depot Profile)

2 - Allocate the Depot Profile to the Itinerary to be used.

3 - Create a Rate to use the depot functionality.

4 - Create two orders:
A -> B
A -> C 

5 - Build a shipment. using the two orders.

6 - The shipment will be A -> B -> C -> A. 

7 - Edit the shipment created and go to the Stops Tab, there will be 4 stops.
     Note: that stop 1 is a pickup and is the same location as stop 4.  This is because it is also a depot. 

8 - Go to Actions > Change Shipment Route > Re-sequence Stops select stop 3 and click move up, then click OK.

9 - The result is the error is displayed 'Stop count is invalid for shipment'.

Cause

Sign In with your My Oracle Support account

Don't have a My Oracle Support account? Click to get started

My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms