Last updated on SEPTEMBER 08, 2016
Applies to:Oracle Transportation Management - Version: 5.5.04
This problem can occur on any platform.
-- Problem Statement:
Splitting ship units from one shipment onto another uses the multistop logic, this in turn
requires the locations to have the latitude and longitude to be populated. For an implementation where rate service is being used and the locations do not have latitude and longitude, splitting ship units fails due to the use of the multistop logic and its requirements.
-- Steps To Reproduce:
1 - Create locations with no latitude and longitude.
2 - Create a rate service to between the source and destination to take 5 hours.
3 - Create a new rate offering (RO) to use the rate service and a new rate record (RR).
4 - Create and order with 3 ship units to be planned over 2 shipments.
Two ship units that each take 60% of one piece of equipment and one much smaller ship unit.
5 - Plan the order onto 2 shipments.
NOTE: These shipments were built with no errors and the destination location has no Lat / Long.
6 - Attempt to split the small ship unit from the first shipment onto the second shipment.
- Select the shipment with the small Ship Unit
- Click on actions > change shipment route > split shipment.
- Select split by ship unit then click OK.
- Select split to parallel shipment.
- Enter in the shipment ID field the ID of the second shipment.
- To the far right of the ID for the small ship unit enter 1 in the split off amount.
- Click OK.
- In the next UI click OK.
- The following error is displayed:
"Failed to built one shipment with the given orders."
The log contains the following entries:
Debug Planning Using MultiStopShipmentBuilder to combine shipment nodes.
Warning Exception Unable to determine LAT/LON for location:LEE.LJS_NO_LAT_OR_LONG
Sign In with your My Oracle Support account
Don't have a My Oracle Support account? Click to get started
Million Knowledge Articles and hundreds of Community platforms