My Oracle Support Banner

Actions Which Support Ignore Planning Constraints does not Honor The Planning Parameter Set Selected From Ignore Planning Constraints Screen (Doc ID 854871.1)

Last updated on MAY 06, 2022

Applies to:

Oracle Transportation Management - Version 5.5.04 to 5.5.05.06 [Release 5.5]
Information in this document applies to any platform.
This problem can occur on any platform.

Symptoms

-- Problem Statement:
On OTM Version 5.5 CU4 & CU5, Actions which support ignore planning constraints does not respect the planning parameter selected form the ignore planning constraint screen and instead it uses the default planning parameter.

For Example If a shipment was planned using planning parameter set X and the domain default parameter set set Z.

If the action,  Resquence Stops is run and the planning parameter X is selected, it is seen that the planning is not respecting that and falls back to the default parameter set Z.

NOTE: That is happening with all actions that support the ignore planning constraints screen.

-- Steps To Reproduce:
The issue can be reproduced at will with the following steps:

1- If not already turned on, Please navigate to Configuration and Administration > User Configuration > Actions Manager > turn on the "ignore constraint" option for RESEQUENCE_STOPS action.
2- Select a shipment > actions > Resequence Stops > from the Ignore Planning Constraints screen select a planning parameter set and click OK > Notice from the logs that OTM is using the default parameter and not the selected one.

Cause

To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!


In this Document
Symptoms
Cause
Solution
References


My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.