My Oracle Support Banner

Fusion QA: Characteristic Sequence Number Jumbled when Setting Up Inspection Plan Using Characteristic Group (Doc ID 2422358.1)

Last updated on AUGUST 21, 2018

Applies to:

Oracle Quality Management Cloud Service - Version 11.13.17.11.0 and later
Information in this document applies to any platform.

Symptoms

Sequence Numbers in which the Inspection Characteristics are loaded into a Characteristic Group are getting jumbled up when pulling them into the Inspection Plan setup.

(for example the first Inspection Characteristic created and added to an Characteristic Group should reflect with Sequence no.10, however it is showing up at Sequence no.80)

Steps to reproduce:
1. Create Characteristics Char1, Char2, Char3;
2. Edit and add all the Char1, Char2, Char3 in the group CharGroup1;
3. Create Inspection plan add the details. In specification Tab add the Characteristics using 'Characteristic Group'

Actual Behavior:

Observe that Char1, Char2, Char3 are added in the same sequence.

Changes

 

Cause

To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!


In this Document
Symptoms
Changes
Cause
Solution


My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.