My Oracle Support Banner

Configure Redundant Disk Array Controller ( RDAC ) Support on Oracle VM 2.1.2 (Doc ID 743536.1)

Last updated on AUGUST 04, 2018

Applies to:

Oracle VM - Version: 2.1.2 and later   [Release: OVM212 and later ]
Linux x86
Linux x86-64
***Checked for relevance on 30-Aug-2011***

Symptoms

You have tried to compile a new Initial Ramdisk with the Redundant Disk Array Controller ( RDAC ) Modules mppUpper and mppVhba, but you get the following Error Message during the Boot Process ( you can check afterwards with the "dmesg" Command ):
MPP:No supported SCSI devices are discovered. Please run "hot_add" after supported storage arrays are attached to the Linux host.

Cause

To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!


In this Document
  Symptoms
  Cause
  Solution

This document is being delivered to you via Oracle Support's Rapid Visibility (RaV) process and therefore has not been subject to an independent technical review.

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.