E-PIA: PT 8.53 Search Empl Record Job Data Not Working. (Doc ID 1920961.1)

Last updated on SEPTEMBER 09, 2015

Applies to:

PeopleSoft Enterprise PT PeopleTools - Version 8.53 and later
Information in this document applies to any platform.

Symptoms

On : 8.53 version, Application Designer

ACTUAL BEHAVIOR
---------------
On the JOB_DATA page, unable to search fro employees with a value of "0" in "Empl Record". However when push the search button, the 0 is removed from the Empl Record box and in the search results there are employees with a value of ‘1’ for employee record.

EXPECTED BEHAVIOR
-----------------------
It should show the search results for the employees with a value of "0" only and not for "1".

STEPS
-----------------------
The issue can be reproduced at will with the following steps:
1. Navigate to Main_Menu>Workforce_Administration>Job_Data >Job_DATA component.
2. Enter the search screen of job data and search for empl record ‘0’ you get an error message, "At least one key field must be entered". This is working fine.
3. Now search for employee record ‘1’ but do not open any page
4. Now search again for employee record ‘0’ and you will see that only results for employee record ‘0’ are shown.
5. So the first time it didn't show the search results for Empl record = "0" but after searching for Empl record " 1" and then searched for Empl record = "0", it gave the results.

BUSINESS IMPACT
-----------------------
The issue has the following business impact:
Due to this issue, the users get confused with the search

Cause

Sign In with your My Oracle Support account

Don't have a My Oracle Support account? Click to get started

My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms