EGL9.2: Receiving Error 'One and only one status should be marked as 'Waiting to be Approved' type. (5700,121)' When Adding a New Reconciliation Status and Reason. (Doc ID 1941581.1)

Last updated on SEPTEMBER 14, 2016

Applies to:

PeopleSoft Enterprise FIN General Ledger - Version 9.2 to 9.2 [Release 9]
Information in this document applies to any platform.

Symptoms

Navigation: General Ledger > Perform Reconciliation > Configurations, Statuses/Reasons > Reconciliation Status and Reason.
There is no existing status, no delivered sample status.

While trying to add a new status with Status Type 'Other', user received below error message relating to Waiting for Approval Status.


ERROR
-----------------------
'One and only one status should be marked as 'Waiting to be Approved' type. (5700,121)'


STEPS
-----------------------
The issue can be reproduced at will with the following steps:
1. Navigate to General Ledger, Perform Reconciliation, Configurations, click link 'Statuses/Reasons'
2. Once Reconciliation Status and Reason page open, verify there is no status pre-defined on the page. Then add a status 'Not Started' with type 'Other'.
3. Upon saving page, Receive an error 'One and only one status should be marked as 'Waiting to be Approved' type. (5700,121)'


Cause

Sign In with your My Oracle Support account

Don't have a My Oracle Support account? Click to get started

My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms