EAM: AM_AMAEDIST.800000.Step10 error after Revaluation in Mass , IUT InterUnit and RETirement (Doc ID 2063280.1)

Last updated on OCTOBER 06, 2015

Applies to:

PeopleSoft Enterprise FIN Asset Management - Version 9.2 and later
Information in this document applies to any platform.

Symptoms

Transfers asset,revalue,Run depreciation process when run Accounting Entires is run the error appear.


ERROR
-----------------------
Process 2651374 ABENDED at Step AM_AMAEDIST.800000.Step10

STEPS
-----------------------
The issue can be reproduced at will with the following steps:

1. ADD asset
2. ADJust asset
3. RETire asset
4. REInstate the retired asset.
5. Calculated the Depreciation
6. Ran the Create Accounting Entry process

OR

1.Add asset,AUS01 asset 0000000017.
2.Run Depr Calc.
3.Run Revaluation in Mass for asset.
4.Run Load Transactions into AM, notice the search returns only the RET txn,Run RET Trans.
5.View PS_Intfc_fin - load status DONE for all transaction.
6.Run Depr Calc.
7.Run accounting entries.
8.Asset Transfer using IUT (AUS01 asset 0000000017, transfer to AUS02,0000000001).
9.Run depr calc for AUS01, asset 0000000017 - we run it for the transfer.
10.Verify the Transfered asset(AUS02,0000000001).
11.Run Revaluation in Mass for transfered asset - AUS02,0000000001.
12.Run Load Transactions into AM, notice the search returns only the RET txn,Run RET Trans.
13.View PS_Intfc_fin - load status DONE for all transaction.
14.Run Depr Calc.
15.Run accounting entries goes to peoplecode error

Cause

Sign In with your My Oracle Support account

Don't have a My Oracle Support account? Click to get started

My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms