EAM: Partial Retirement Via Transaction Loader Populates Retirement Percent Incorrectly As -1 (Doc ID 2143656.1)

Last updated on JULY 11, 2016

Applies to:

PeopleSoft Enterprise FIN Asset Management - Version 9.1 and later
Information in this document applies to any platform.

Symptoms

When partially retiring an asset by a cost/qty fraction, the retirement values are populated accordingly but the retirement_pct in the ps_retirement table is still 1. When the same partial retirement is entered via the Retire/Reinstate Asset component, the retirement_pct is populated per the entered cost/qty fraction.

Expected Behavior
-------------------------
The expectation is that the retirement_pct will be populated per the cost/qty fraction entered in the mass change template just as it is populated when the cost/qty fraction is entered on the Retire/Reinstate Asset component.

Steps
---------
This issue can be replicated by performing the following steps:

1) Partially retire an asset via the Retire/Reinstate Asset page. Verify Retirement_PCT in the ps_retirement table.
2) Partially retire an asset via the Partial Retire Proceeds Absolu Mass Change Template. Verify Retirement_PCT in the ps_retirement table.
3) Partially retire an asset via the Partial Retire Proceeds Dist Mass Change Template. Verify Retirement_PCT in the ps_retirement table.

Cause

Sign In with your My Oracle Support account

Don't have a My Oracle Support account? Click to get started

My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms