PC_EXPRSS_AM Sending Transaction Multiple Times To Asset Management Under Some Scenarios. (Doc ID 2154453.1)

Last updated on JUNE 30, 2016

Applies to:

PeopleSoft Enterprise FIN Project Costing - Version 9.2 to 9.2 [Release 9]
Information in this document applies to any platform.

Symptoms

On : 9.2 version, Project Assets

ACTUAL BEHAVIOR
---------------
PC_EXPRSS_AM process for incorrectly sending transactions to AM that were already distributed to Asset once'

EXPECTED BEHAVIOR
-----------------------
PC_EXPRSS_AM process should not send transactions to AM multiple times if they have been already distributed earlier.

STEPS
-----------------------
The issue can be reproduced at will with the following steps:
1. Create a Project
2. Go To Asset Integration Rules tab - Turn on Enable Integration - Capitalization checked, Asset Identification Rule - "Many Assets From Each Activity" and choose "Activity percent Distribution", Asset Creation Trigger - "Asset In service Date"
3. Create an Activity
4. Define Express Asset - 100% to one asset. In service date of asset is today.
5. Create a ACT of $2000 and process
6. Run PC_EXPRSS_AM process. $2000 COST goes to INTFC_FIN as expected.
7. Create a ACT of $7000 and process
8. Run PC_EXPRSS_AM process. $9000 COST goes to INTFC_FIN. Expectation is to send only $7000 this time as $2000 was already distributed during the earlier run.
9. When PROJ_RESOURCE is reviewed, you will see 2 rows with $2000 and AM_DISTRIB_STATUS ='D' which is incorrect.

Cause

Sign In with your My Oracle Support account

Don't have a My Oracle Support account? Click to get started

My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms