ETL9.2: When Making A Change To an Already Reported Time, The Reported Time Audit History page still shows the old time. (Doc ID 2266253.1)

Last updated on JUNE 13, 2017

Applies to:

PeopleSoft Enterprise HCM Time and Labor - Version 9.2 to 9.2 [Release 9]
Information in this document applies to any platform.

Symptoms

On : 9.2 version, Other

ACTUAL BEHAVIOR
---------------
When making a change to an already reported time it does not show on the Reported Time Audit history page. It still shows the old time reported.

EXPECTED BEHAVIOR
-----------------------
The change should be seen on the clocking page

STEPS
-----------------------
The issue can be reproduced at will with the following steps:
1-Report time through the timesheet page.
2-audit the reported time-->(Time and Labor--> Reports --> Reported Time Audit)

3-Go back and change the same audited time.

4-Run the audit report time process again. 

5-The time that was audited and the time that was changed does not show on the audit page. (Time and Labor--> View Time --> Reported Time Audit)

BUSINESS IMPACT
-----------------------
The issue has the following business impact:
Due to this issue, users cannot see correct data on the audit time history page.

Cause

Sign In with your My Oracle Support account

Don't have a My Oracle Support account? Click to get started

My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms