My Oracle Support Banner

EGL: 9.2 Fluid Workcenter Personalize Run Control For Reports/Processes Not Working (Doc ID 2452252.1)

Last updated on FEBRUARY 01, 2019

Applies to:

PeopleSoft Enterprise FIN General Ledger - Version 9.2 to 9.2 [Release 9]
Information in this document applies to any platform.

Symptoms

On :  9.2 version, Functionality

ACTUAL BEHAVIOR  
---------------
In the personalize window of any Fluid Workcenter, in the Reports/Processes tab, if you enter a default run control and save, this is supposed to default the run control when you run this report via the Workcenter, and it is not working.


STEPS
-----------------------
The issue can be reproduced at will with the following steps:
1.Access  Fluid workcenter, under Reports/Processes
2. Select a report, add a new run control
3. Save the run control
4. Under the workcenter Personalize menu, enter the run control ID for the report it was created for.  Click Done.
5. Go back to the same report in the workcenter.  It should bypass the run control search page and open the entered run control ID from the personalize page.  



Changes

 

Cause

To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!


In this Document
Symptoms
Changes
Cause
Solution
References


My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.