E-Fluid: Unable To Add New Run Control ID From Fluid Run Control Page (Doc ID 2501679.1)

Last updated on NOVEMBER 14, 2019

Applies to:

Symptoms

On : 8.56.10 version, Fluid UI

ACTUAL BEHAVIOR
---------------
Unable to add new Run Control ID from Fluid Run Control page

Converted classic run control page to Fluid run control page. Unable to add new Run Control ID from Fluid Run Control page and getting below Error message.

"Run Control ID must have a value"

EXPECTED BEHAVIOR
-----------------------
Fluid mode Run Control page should allow to add new Run Control ID

STEPS
-----------------------

1) Using Apps Designer Create New Fluid page
2) Selected the Layout type as PSL_APPS_CONTENT
3) Given the fluid page name as DSC_ATT_MASS_U_FL
4) Placed delivered run control subpage - PRCSRUNCNTL_SBP on the Fluid page.
5) Created a new component - DSC_ATT_MASS_U_FL and added the fluid page into the component.
6) Enabled fluid mode option in the component properties.
    a) Fluid Mode selected under Component Attributes
    b) Component Type - Standard
    c) Search Page Type - Standard
7) Registered the component.
    CRF: Root > Student Admissions >DSC_ATT_MASS_U_FL_GBL
8) To handle component search mode , created new pivot grid with data source type as Component.
9) Open New Fluid Run Control page
10) Click Add button
11) Enter Run Control ID ..eg : 11
12) Click Add
13) Getting  below error

"Run Control ID must have a value"

References:

Converting Classic PIA Components to PeopleSoft Fluid User Interface (Doc ID 1984833.1)

Changes

Cause

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.