My Oracle Support Banner

EAM:When Configuring the Auto Retire Fully Depreciated Asset Run Control, for 2 Request Ids, AM Auto Retire Component Updates the INTFC_ID Incorrectly for the Second Request ID. (Doc ID 2897880.1)

Last updated on JUNE 22, 2023

Applies to:

PeopleSoft Enterprise FIN Asset Management - Version 9.2 to 9.2 [Release 9]
Information in this document applies to any platform.

Symptoms

When configuring the auto retire fully depreciated asset Run Control, for 2 request IDs. The interface ID is updated for only requested ID 1 on RUN_AMRET_IF1000 page . For request ID 2 there is no interface ID present on RUN_AMRET_IF1000 page.

The following results were observed when the Request ID 2 was deleted:

a) The Request ID 2 is still present on RUN_AMRET_IF1000 page, expected result is that it should not be present.

b) The interface ID updated to some new value, which is incorrect.


Steps to Replicate:

1) Ensure Auto retire fully depreciated assets is enabled on BU level on CORP Book for BUs US001 and US002.
     Menu > Set up Financials / Supply Chain > Business Unit Related > Asset Management > Asset Management Definition.

2) Navigate to Asset Management > Asset Transactions > Asset Disposal > Auto-Retire Fully Depr Assets.

3) Create a new run control, add 2 Request IDs and save the page.

4) Review RUN_AMRET_IF1000 page for both the request IDs. Interface ID is not available for second request ID.

Replication Steps.

Changes

 

Cause

To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!


In this Document
Symptoms
Changes
Cause
Solution
References


My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.