EPY: Retropay Inflates Amount For Additional Pay calculated Based on Special Accumulator Hours. (Doc ID 3057409.1)

Last updated on DECEMBER 05, 2024

Applies to:

Symptoms

Retro Pay is inflating amounts for certain scenario.

An earning has been created and it is calculated based on hours from an special accumulator. Also it used Unit/Override Rate.

The issue happens when the earning is added in the Additional Earnings and a pay rate change happens in the same period.

It is not expected any change in the amount for this earning.

Steps to reproduce the issue:

1. Navigate to Set Up HCM > Product Related > Payroll for North America > Compensation and Earnings -> Earnings Table and create the earnings CVA:

Multiplication Factor: 1.000

Based on Other Earnings/Hours

Special Accumulator: HRS

Based on Employment Records

Based on Amount or Hours:Hours

2. Navigate to Workforce Administration > Job Information > Job  Data.  and add a Pay Rate change for Empl_rcd 1.
  Effective Date 10/22/2023
  Comp Rate NAHRLY 26.34
 
After: Empl_Rcd 1
  Effective Date 01/14/2024
  Comp Rate NAHRLY 29.34

3. Navigate to Payroll for North America > Employee Pay Data USA > Create Additional Pay. Add an additional pay for Empl_rcd 0 with the CVA EFFDT 10/22/23, Addl Seq Nbr 1, OK to pay checked.
 
4. Navigate to Payroll for North America > Retroactive Payroll > Retro Pay > Process and Review Requests > Calculate Retroactive Pay and run the process.

5. Navigate to Payroll for North America > Retroactive Payroll > Retro Pay > Process and Review Requests > Retropay Calculation Results and review the results.

Changes

Cause

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.