Can't change the IP address on Sun StorEdge[TM] T3+ storage array
(Doc ID 1009558.1)
Last updated on SEPTEMBER 11, 2019
Applies to:
Sun Storage T3+ Array - Version All Versions to All Versions [Release All Releases]All Platforms
Symptoms
On a Sun StorEdge[TM] T3+ storage array it was observed that the IP address could not be changed.
The change was attempted from the PSOS prompt. It was observed that even a temporary change at the EP prompt would not hold through reboots. Below are the steps that were performed but were NOT Successful in changing the IP address:
- set ip yyy.yyy.yyy.yyy (command at the PSOS prompt)
- set (to verify the change)
- reset
- interrupted the boot cycle, ran set to verify change (still old IP exists)
- boot from EP prompt
- set command reports the IP as xxx.xxx.xxx.xxx (old IP)
Changes
Cause
To view full details, sign in with your My Oracle Support account. |
|
Don't have a My Oracle Support account? Click to get started! |