Solaris Cluster Manipulating Quorum Maintenance/Reset/Add/Remove Quorum Device (Doc ID 1010502.1)

Last updated on DECEMBER 06, 2016

Applies to:

Solaris Cluster - Version 3.0 to OSC 4.3 [Release 3.0 to 4.3]
Oracle Solaris on SPARC (64-bit)
Oracle Solaris on x86-64 (64-bit)

Goal

This document is intended as a complete treatment of the manipulation of quorum in Solaris Cluster to perform maintenance. It is not a maintenance procedure in itself, but rather a "helper" for any quorum situation.

The document use the old command line interface from 3.1 and earlier, but you can also use equivalent commands from new command line interface of Solaris Cluster 3.2 and higher.

Solution

Sign In with your My Oracle Support account

Don't have a My Oracle Support account? Click to get started

My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms