My Oracle Support Banner

Sun StorEdge[TM] 2G switch troubleshooting using log commands (Doc ID 1012402.1)

Last updated on JUNE 17, 2019

Applies to:

QLogic SANbox 5600 Switch - Version Not Applicable and later
All Platforms


Occasionally, it may be necessary to inspect the protocol exchange between a device and a Sun/Qlogic 2G Fibre Channel Switch to assist in diagnosing an issue.

The Qlogic/Sun Sanbox2 2G switch has a good set of log commands that can assist in troubleshooting a fibre channel issue. (These are not present on the 1G device.)
By default, the switch is set to log only critical events, but if a problem is currently occurring, then setting the log level to info (informational) can produce a large amount of diagnostic information.

Troubleshooting Steps

To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.