Sun StorEdge T3 Array: Automating "vol verify"
(Doc ID 1018618.1)
Last updated on SEPTEMBER 08, 2019
Applies to:
Sun Storage T3 Array - Version Not Applicable and laterSun Storage T3+ Array - Version Not Applicable and later
All Platforms
Goal
On the Sun StorEdge T3 using firmware 2.x, "vol verify" may be automated by using a shellscript and cron.
NOTE :
2.x Firmware : The appropriate method of automating the run of "vol verify" on 2.x or lower firmware is through StorADE.
3.x Firmware : Oracle strongly recommends having T3 firmware 3.x "disk_scrubber" parameter set to ON.
Why is having T3 firmware 3.x "disk_scrubber" parameter set to ON strongly recommend?
The whole point of 3.x having disk_scrubber is to prevent a much bigger issue of data loss due to multiple disk failure before it is too late. The "disk_scrubber" should NOT be switched off.
Solution
To view full details, sign in with your My Oracle Support account. |
|
Don't have a My Oracle Support account? Click to get started! |