Sun Storage[TM] 6x80 and 2500-M2 Array Controller 7-Segment Display
Last updated on AUGUST 03, 2017
Applies to:Sun Storage 6580 Array - Version Not Applicable and later
Sun Storage 2530-M2 Array - Version Not Applicable and later
Sun Storage 2540-M2 Array - Version Not Applicable and later
Sun Storage 6180 Array - Version Not Applicable and later
Sun Storage 6780 Array - Version Not Applicable and later
Decode array RAID controller's 7-segment display to determine if a problem exists which requires further troubleshooting.
The 7-segment displays on these arrays are dynamic. Under optimal conditions they will display the tray ID, which is 85 for 6180 and 99 for the 2500-M2, 6580 and 6780 arrays by default. The tray ID is the only display that is static on these array controllers.
On boot, the array controllers will go through a rapid sequence of displays, which indicate the points in the boot up sequence that the controllers are performing. This document is intended to describe the dynamic display pattern, which is repeated if the boot up sequence stops.
Sign In with your My Oracle Support account
Don't have a My Oracle Support account? Click to get started
My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms