My Oracle Support Banner

How to Replace a Sun Fire X2100 M2 HDD (Doc ID 1349111.1)

Last updated on AUGUST 22, 2018

Applies to:

Sun Fire X2100 M2 Server - Version Not Applicable and later
Information in this document applies to any platform.

Goal

How to Replace a Sun Fire X2100 M2 HDD.

Solution

To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!


In this Document
Goal
Solution
 1a. - If the disk is mirrored using Solaris Logical Volume Manager
 1b.- Powering Off the server (if disk is not mirrored):
 2. Squeeze the release latch and carefully swing the arm to the left as far as it will go.
 3. Grasp the carrier bezel with both hands and carefully pull the carrier out of the drive bay.
 4. Install the new disk, Squeeze the release latch and carefully swing the arm to the left as far as it will go.
 5. Grasping the body of the drive in both hands, carefully guide the connector end of the carrier into the drive bay, sliding the carrier into the bay until the arm engages and partially closes itself.
 6. Push the arm forward and latch it to lock the carrier in place.
 7a. If the disk was mirrored :
 7b. If the disk was not mirrored, restore the data to the disk from a previous backup
References

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.