Failed Drive Alarm May Not Clear Automatically After Drive Replacement When Drive is Assigned to an Empty VDISK (Doc ID 1496245.1)

Last updated on FEBRUARY 14, 2015

Applies to:

Sun Storage 2530-M2 Array - Version Not Applicable to Not Applicable [Release N/A]
Sun Storage 2540 Array - Version Not Applicable to Not Applicable [Release N/A]
Sun Storage 2540-M2 Array - Version Not Applicable to Not Applicable [Release N/A]
Sun Storage Flexline 380 Array - Version Not Applicable to Not Applicable [Release N/A]
Sun Storage 6540 Array - Version Not Applicable to Not Applicable [Release N/A]
Information in this document applies to any platform.

Symptoms

After a failed disk drive is replaced, the new disk reports as Optimal, however, the alarm for the disk failure never clears.

 

This problem is only known to occur in 25x0 and 6xx0 arrays running 7.x versions of controller firmware.

 

Changes

 The failed Disk Drive was replaced in the array.

Cause

Sign In with your My Oracle Support account

Don't have a My Oracle Support account? Click to get started

My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms