Pillar Axiom: How to check a Brick Bezel Connector Ribbon Cable is seated correctly (Doc ID 1498228.1)

Last updated on MAY 16, 2017

Applies to:

Pillar Axiom 500 Storage System - Version Not Applicable to Not Applicable [Release N/A]
Pillar Axiom 300 Storage System - Version Not Applicable to Not Applicable [Release N/A]
Pillar Axiom 600 Storage System - Version Not Applicable to Not Applicable [Release N/A]
Information in this document applies to any platform.

Goal

This Action Plan is to be used to determine the ribbon cable is connected securely to the Brick Bezel Connector PCB located on the Brick chassis behind the bezel.

A Healthy Brick should always monitor Brick Bezel status. When you remove brick bezel you should see Informational event notifications with location details at the AxiomOne GUI: (Examples below)
Informational BrickBezelRemoved /Brick003 RC-1

When you reconnect the brick bezel you should see similar event notifications:
Informational BrickBezelInserted /Brick003 RC-1

If these events are not detected, you should check Brick bezel connector using this procedure:

 

Solution

Sign In with your My Oracle Support account

Don't have a My Oracle Support account? Click to get started

My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms