Fan Status is Reported in Initial Status(1) by SNMP Get (Doc ID 2192164.1)

Last updated on MAY 17, 2017

Applies to:

Acme Packet 3820 - Version E-Cx6.3.x and later
Information in this document applies to any platform.

Symptoms

SBC Administrators may receive a Fan status change alarm as a value of initial(1) from snmp trap, or may notice Fan status is in initial status(1) by SNMP get.

In this scenario, snmpwalk on fan status shows as below:

There is no related alarm in the display-alarms output.

All outputs of below commands look fine.

show health
show power
show voltage
show temp
show fans
 

The fan itself works fine.

Cause

Sign In with your My Oracle Support account

Don't have a My Oracle Support account? Click to get started

My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms