SCTP Connection Parameters From "Connection Configuration Set" Not Taken Into Account by DSR
(Doc ID 2257682.1)
Last updated on JUNE 08, 2023
Applies to:
Oracle Communications Diameter Signaling Router (DSR) - Version DSR 7.3.0 to DSR 7.4.0 [Release DSR 7.0]Information in this document applies to any platform.
Symptoms
DSR aborts the SCTP connection after 1000 ms while "Retransmit Maximum Timeout for INIT" parameter in "Connection Configuration Set" is set to a higher value (>1000ms).
In the following example, the applied "Connection Configuration Set" is including the following parameter:
- Retransmit Initial Timeout: 2000ms
- Retransmit Minimum Timeout: 2000ms
- Retransmit Maximum Timeout: 2000ms
- Retransmit Maximum Timeout for INIT: 2000ms
However, in the below capture, the MP (1.1.1.1) is sending an ABORT 1000ms after the INIT was sent:
Changes
Cause
To view full details, sign in with your My Oracle Support account. |
|
Don't have a My Oracle Support account? Click to get started! |
In this Document
| Symptoms |
| Changes |
| Cause |
| Solution |
| References |