QConvergeConsole CLI qaucli Slow Or Fails To Start
(Doc ID 2276802.1)
Last updated on OCTOBER 05, 2022
Applies to:
SPARC T4-2 - Version All Versions and laterSolaris Operating System - Version 10 3/05 and later
Solaris x64/x86 Operating System - Version 10 3/05 and later
SPARC T7-2 - Version All Versions and later
SPARC T5-2 - Version All Versions and later
Information in this document applies to any platform.
Symptoms
QConvergeConsole CLI qaucli is slow or fails to start. This utility is required to update firmware on Oracle branded QLogic HBAs and is typically installed into one of the following locations:
/usr/lib/ssm/fwupdate/qlogic/qaucli
/opt/QLogic_Corporation/QConvergeConsoleCLI/qaucli
Changes
Large configurations are more likely to run into this issue. For example, on a system where there are 2500 LUNs presented on 4 paths, 2 behind each HBA, equates to 10,000 discreet LUN paths. It takes at least three IOCTLs to each target and LUN to discover all the information, resulting in over 30,000 IOCTLs. The update_sol.sh script included with multiboot updates starts qaucli 15 times. It could take an entire day to complete the update.
Cause
To view full details, sign in with your My Oracle Support account. |
|
Don't have a My Oracle Support account? Click to get started! |
In this Document
| Symptoms |
| Changes |
| Cause |
| Solution |
| References |