My Oracle Support Banner

EPAP 16.1| Switch configuration | ERROR: Could Not Transfer Config File! (Doc ID 2541324.1)

Last updated on AUGUST 27, 2020

Applies to:

Oracle Communications EAGLE (Software) - Version EPAP 16.1 and later
Information in this document applies to any platform.

Symptoms

Switch configuration | ERROR: Could Not Transfer Config File! The speed/duplex setup was not correctly configured on the Switch 1B. The speed/duplex should be the same on the STP as well as EPAP. Alarm: 100000000000001 being seen

Changes

 While the configuration of switch is simple and is shown on the MOP :

Page 48 procedure 9

-----------------------------------------
But in our case, the configuration was failing to be implemented.


line 362.

Cause

To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!


In this Document
Symptoms
Changes
Cause
Solution


My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.