During config.sh on the Second Node of a Cluster, the EM FMW Control console > "Agent-Monitored Targets" Page Shows OID 11g Components (OID2, OVD2 and DIP2) with "Needs Configuring" Under the "Agent" Column (Doc ID 1923497.1)

Last updated on MAY 19, 2021

Applies to:

Goal

Due to issues in <Document 1921402.1>, reinstalled both clusters but this time also checking the Enterprise Manager (EM) targets during the installation.

After the second OID config.sh was completed on both second cluster nodes, noticed that the EM Targets were showing all of the OID components (e.g., OID2, OVD2 and DIP2) for Node2 with "Needs Configuring" (under "Agent" in EM Fusion Middleware (FMW) Control console > Farm_Domain > Agent-Monitored Targets page).

So went into EM and configured each of those targets manually, so that the Agent pointed to the correct Node2 for each component before continuing.

Afterwards, the previously experienced problems (<Document 1921402.1>) no longer occurred.

Is it expected to have to configure the targets that show "Needs Configuring" this way, during installation/configuration?

Below are samples from EM screen shot pages recorded:

1.  After completing configuration on Node1, EM Agent-Monitored Targets showed all Node1 components up and running:

2.  After completing the second configuration on Node2 of the cluster, noticed that all three OID components (OID2, OVD2 and DIP2) are showing with "Needs Configuring" under the Agent column:

3.  Before clicking OK to finish the Configuration, selected the blue Configure icon for each OID component Node2, verifying that the Agent selected and listed was correct for each component.

4.  After completing the configuring each of the OID components for Node2, then the results looked correct:

Solution

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.