My Oracle Support Banner

Golden Gate - Extract Process Capturing Changes Only After x Hours (Doc ID 2691169.1)

Last updated on SEPTEMBER 25, 2020

Applies to:

Oracle GoldenGate - Version and later
Information in this document applies to any platform.


After initial load completed for one particular table, tried to test transactions (DMLs), and noticed that DMLs are not getting replicated to target for almost X hours. After X hours when the replication was started, its working fine. But the X hours of transactions happened in source is lost. If the extract process is started before kicking off initial load, the initial load is successful.

After X hours , we got below output saying recovery complete. Then new set of transactions are replicating fine. But the transactions happened in those X hours are not replicated.


To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!

In this Document

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.