ENUM Call Out (ENCO) Processing Fails to Lookup a Valid Number and ENCO Node Exits the Fail Branch (Doc ID 1542950.1)

Last updated on SEPTEMBER 12, 2016

Applies to:

Oracle Communications Network Charging and Control - Version 5.0.0 and later
Information in this document applies to any platform.

Symptoms

The ENUM (Electronic Number Mapping) Call Out (ENCO) node does not lookup a number and exits the Fail branch of the control plan node.  The connection between SLC (Service Logic Controller) and ENUM database is up and a valid entry exists in the database.

When slee_acs DEBUG is enabled, the following message shows the following output:

 

Changes

Editing a control plan's ENCO node after installing or upgrading to Network Charging and Control (NCC) version 5.0.0.1.0 (Intrepid Patch Set 1).

Cause

Sign In with your My Oracle Support account

Don't have a My Oracle Support account? Click to get started

My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms