360 Initial Measurement Overlay Zone Does Not Populate Start and End Date/Time by Default
(Doc ID 2485963.1)
Last updated on MARCH 07, 2024
Applies to:
Oracle Utilities Meter Data Management - Version 2.1.0.3 to 2.1.0.3 [Release 2.1]Information in this document applies to any platform.
Symptoms
360 Initial Measurement Overlay zone doesn’t populate the start and end date/times by default.
Steps To Recreate
- Create a CM child BO of either "D1-InitialLoadIMDInterval" BO or "D1-ManualIMDInterval" bo. I used "D1-InitialLoadIMDInterval" BO.
- Create Device, Device configuration, Interval Measuring component, Service point and Install event.
- Create IMD’s/Measurements an Interval MC thru XAI submission.
- Search for the MC and navigate to 360 MC Interval – Initial Measurement Overlay zone.
- Observe that start and end date/times are blank by default.
Cause
To view full details, sign in with your My Oracle Support account. |
|
Don't have a My Oracle Support account? Click to get started! |
In this Document
Symptoms |
Cause |
Solution |
References |