MSS 6.3 - Adding and Removing Node Address Overrides Deletes Ports
(Doc ID 2675459.1)
Last updated on JUNE 15, 2020
Applies to:
Oracle Communications MetaSolv Solution - Version 6.3.0.1 and laterInformation in this document applies to any platform.
Symptoms
MSS 6.3.0.1003 | Equipment Specs and Installation With Multiple Rate Codes
============= ==================================
ACTUAL BEHAVIOR
============
Adding and removing node address overrides deletes ports
EXPECTED BEHAVIOUR
==============
Adding and removing node address overrides SHOULD NOT delete ports in the equipment
STEPS
=====
Suppose there is an equipment spec, has one physical port ("one") with DS3 and STS1 rate codes, and one normal port ("two") with an STS1 rate code.Each row has 28 level two DS1 enabled ports.
1-A new piece of equipment is added from this spec. At this point the rate code drop-down for port one is working normally.
2-A hard override node address is added to port one.
3-The override works normally.
4-The override is removed.
Problem: This action deletes port one, and all its enabled ports.This is permanent, and the equipment no longer matches its own spec.
WORKAROUNDS
===========
If the Override is added and removed using the Equipment-Edits screen , the issue is not seen .
Cause
To view full details, sign in with your My Oracle Support account. |
|
Don't have a My Oracle Support account? Click to get started! |
In this Document
Symptoms |
Cause |
Solution |
References |