UIM 7.4.1|"Associate Logical Device" Tab "Specification" Drop-down Does Not Show All Parent LD Specifications (Doc ID 2848174.1)

Last updated on NOVEMBER 13, 2023

Applies to:

Symptoms

On : 7.4.1.0.0 version, Logical Devices

*********************************


ACTUAL BEHAVIOR

-----------------------------
Under "Associate Logical Device" tab "Specification" drop-down does not show all LD specifications .

Created LogicalDevice, and have to associate it to the ParentLogical Device of particular specification. But ,while associating Parent LogicalDevice to the child LogicalDevice in "Associate Logical Device" tab , the "Specification" drop-down does not show all the available LogicalDevice specifications.
 

EXPECTED BEHAVIOR
---------------------------------
While associating Parent LogicalDevice to the child LogicalDevice in "Associate Logical Device" tab "Specification" drop-down should show all the available LogicalDevice specifications.


STEPS
------------
The issue can be reproduced at will with the following steps:
1-Create 4 LD Specs in Design Studio (Say LD1,LD2,LD3,LD4). Make LD1, LD2,LD3 as parent specs for LD4.

2-In UI ,create LogicalDevice based on LD4.

3-Try to associate it to the ParentLogical Device.While associating Parent LogicalDevice to the child LogicalDevice in "Associate Logical Device" tab "Specification" drop-down does not show all the available parent LogicalDevice specifications. Only one is coming up currently

Cause

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.