Batch Parameters selection (Yes/No) changes every time when we open a sub-run and open Run-Executable (Doc ID 3000800.1)

Last updated on FEBRUARY 02, 2024

Applies to:

Symptoms

On : 8.0.8 version, Password Reset utility

ACTUAL BEHAVIOR

---------------

Batch Parameters selection (Yes/No) changes every time when we open a sub-run and open Run-Executable :Whatever Run Executable activity is opened first in a workflow- Batch Parameter will show as 'Yes' and all other Run executable will have Batch Parameter as No when opened second time.Expected behavior is to show the Batch parameter correctly every time.

EXPECTED BEHAVIOR

-----------------------

Batch parameter should show the correct/configured value every time when opened to view the details.

STEPS

-----------------------

The issue can be reproduced at will with the following steps:

1. Open a workflow (which has sub-run that contains run-executable task)in PMF Modeller

2. Open the Run-Executable activity that and view the properties it shows as 'Yes' as per the configuration

3. Navigate back to original workflow and open the run-executable again and see tht parameter value changes to No.

BUSINESS IMPACT

-----------------------

The issue has the following business impact:

Due to this issue, users cannot able to use the Batch parameter properly during the execution.

Changes

 NA

Cause

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.