SUPI Range Array Is Accepting Only One Range (Doc ID 3005579.1)

Last updated on FEBRUARY 23, 2024

Applies to:

Symptoms

The issue is regarding setting (Subscription Permanent Identifier) SUPI Range in Network Repository Function (NRF).

Scenario:

• The user has setup two different ranges (non-continuous) of SUPI.
  For Example:
  4401000000000000 - 4401000000000999
  4409000000000100 - 4409000000001999
  
  
• Note that user cannot configure one single range [4401000000000000 - 4409000000001999] as it is a part of the mobile virtual network operator (MVNO).
  
  
• User configured the following parameters via JCONSOLE as:
  supiRangeListStart="4401000000000000,4409000000000100"
  supiRangeListEnd="4401000000000999,4409000000001999"
  
  
• Now issue is that while Charging Function (CHF) sends a request towards NRF for Registration, it sends as:
  <supiRangeList
  {
  start: 4401000000000000,4409000000000100
  end: 4401000000000999,4409000000001999
  }/>
  
  
• Since supiRangeList is an Array as mentioned by the specifications, the user expects the following format:
  <supiRangeList
  {
  start: 4401000000000000
  end: 4401000000000999
  }
  {
  start: 4409000000000100
  end: 4409000000001999
  }/>

Cause

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.