Fusion CST Extended Cost For An Item With Dual UOM Not Calculated Properly In Rollup (Process Manufacturing) (Doc ID 2780521.1)

Last updated on SEPTEMBER 23, 2023

Applies to:

Symptoms

ACTUAL BEHAVIOR
---------------
User is using process manufacturing and has items with dual UOM (Catch weight new functionality ). e.g. primary unit is case and secondary unit is pound. Standard cost and cost is based on secondary unit (pound)

Routing is based on pounds with output in primary UOM (case)

For sample item, 1 pound = 0.0113169 case

When user rolls up case, unit cost is calculated correctly but extended cost is not getting calculated correctly.Unit cost gets calculated for each pound and then it multiplies by 0.0113169 to get extended cost (Case), while it should divide by 0.0113169 to get case cost?

It works correctly for items with single UOM.
 

EXPECTED BEHAVIOR
-----------------------
the extended cost should be correct

STEPS
-----------------------
The issue can be reproduced at will with the following steps:
1. perform cost roll up
2. review cost

Changes

Cause

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.