When Running A "Cross Tab" Type User Defined Report (UDR), the "Total" Column Is Displayed To the Left In the Report Results (Doc ID 2961377.1)

Last updated on JULY 19, 2023

Applies to:

Symptoms

When running a "cross tab" type User Defined Report (UDR), the "Total" column is currently being displayed in the second column from the left, just after the "Name" column. In this case the problem was noticed after a Unifier upgrade to version 23.4.

EXPECTED BEHAVIOR
----------------------------
In a cross tab UDR the "Total" column is expected to be displayed on the far right of the report as it is totaling the other columns in the report.

STEPS
-----------------------
The issue can be reproduced at will with the following steps:

1. Log into the Unifier environment.
2. Navigate to the Project/Shell where the UDR is configured > User Mode > Reports > User-Defined > Find "UDR1" > Enter desired Report Parameters > Run Report.
3. In the resulting report, note that the "Total" column is displayed 2nd from the left on the far left side of page and not on the far right of the report as expected.

Changes

Cause

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.