Cash Flow Properties, Curve Cost Is Being Reset to Manual (Doc ID 2987237.1)

Last updated on NOVEMBER 16, 2023

Applies to:

Symptoms

In the Cash Flow Properties, for any Curve's Cost, when set to X, or anything other than "Manual":

Expected Result

When viewing the Curve's Cost in the Cash Flow Properties the Cost should be seen as "X" -and- when opening the properties for the Curve itself the Cost setting should also be seen as "X".

Actual Result

When viewing the Curve's Cost in the Cash Flow Properties the Cost should be seen as "X" -however- when opening the properties for the Curve itself the Cost setting is seen as "Manual".

This is observed at both the Template level and Project/Shell level.

Steps to Reproduce

1. In either the Template and/or Project/Shell, Open the Cash Flow Properties.
2. Notice for any Curve that the 'Cost' setting is seen as "X".
3. Open the Curve and notice that the 'Cost' setting is seen as "Manual".
4. Change the 'Cost' setting from "Manual" to "X".
5. Click on the 'Update' button.
6. Click on the 'Save & Close' button.
7. Open the Cash Flow Properties.
8. Notice that items 2 through 6 are once again observed.

Cause

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.