R12: PAXACMPT PRC: Update Project Summary Amounts Debug Data Writing Too Much Data To Reports.log File (Doc ID 1482093.1)

Last updated on NOVEMBER 16, 2022

Applies to:

Symptoms

PAXACMPT PRC: Update Project Summary Amounts is writing too much data to the log file even with PA:Debug Mode profile option set to "No".

Issue also occurs for PAXACRPT - PRC: Refresh Project Summary amounts.

According to Note:844976.1 All Concurrent Reports Are Failing With Error
REP-0004,REP- 0082 And REP-0104, the 2GB is a limit, so that can't be
increased. Can this output be limited?
  
Solution
When the process is run as a Range, one of the parameters is 'Generate
Report Output'. When this is set to no, there is minimal output.
 
However, this limits the output report as well as the log file.
  
The problem is that messages that are written to the log files of
concurrent for Oracle Reports also are written to the reports.log file. The
messages that are being written to the log file are debug messages and
should be controlled by the PA Debug parameter, not the Generate Report
Output parameter.

Changes

Cause

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.