Depot Repair: Non-Standard WIP Job: Assembly Pull Items Cannot Be Added As Material Requirements - Push Items Defaulted with Wrong Sub-Inventory (Doc ID 1667626.1)

Last updated on JUNE 06, 2023

Applies to:

Symptoms

On 12.1.3 - Repair Execution:

Actual Behaviors:

1. Technician's Portal helps users to add Material Requirements to the Non-Standard WIP Job.
  When adding the materials, it was noticed that some of the materials did not get added to Technician's Portal after entering them and clicking on the Save / Apply button.
  The Items did not get into the material requirements table.

2. Service Repair created job is defaulting with wrong sub-inventory as the material supply sub-inventory.
  When creating a Service Request complete estimate, create non-standard Repair Job.
  The job is incorrectly created with 'FG' (Finished Good) as the material supply sub-inventory.

Steps:

1.

(R) Depot Repair Super User
(N) Depot Repair > Technician Portal.
 - Add an "Assembly Pull" item as a material requirement for a Non Standard WIP Job.
 - Save.

2.

(R) Depot Repair Super User
(N) Repair Order form
 - Create Service Request
 - Create a Repair Order
 - Created a Non-Standard job successfully with material requirements.

(N) Work in Process (WIP)
 - Query the Job
 - Open the Material Requirements window. The 'Main' tab shows the Components.
 - Navigate to the 'Supply' tab.

 => 'FG' appears as the Supply sub-inventory for all components.

In the WIP Parameters form > Material tab, the value for Supply Subinventory is "RM".
Also Items are set as 'Push' and no sub-inventory or locator is defined.

Changes

Cause

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.